Phoenix & the Valley · Water damage helpMon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET
Home › Services › Flood Damage Cleanup

Flood Damage Cleanup in Phoenix, AZ

Flood water comes from outside — monsoon rain, a storm burst, water that overwhelmed a drain or ran in under a door. Cleanup removes the water, dries what it touched, and cleans surfaces that flood water contaminated.

Call Now

Phoenix & the ValleyExtraction, drying & cleanupMoisture readings on every job

Need help with water damage?

Call Now to reach a local water damage professional. Describe the water, where it is, and what it has touched.

Call Now

Hours: Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

1
Stop the water firstShut off the supply if it is safe, then get the water out.
2
Find the hidden waterMoisture checks look past the surface into walls and floors.
3
Dry it properlyAir movers and dehumidifiers dry structure, not just the surface.
4
Document everythingPhotos and notes help when you talk to your insurer.
Flood Damage Cleanup

What this service does

Phoenix gets less than eight inches of rain a year, and roughly half of it arrives in the monsoon window from June 15 to September 30. That is the paradox of desert flooding: the ground is baked hard, much of the metro is paved, and a monsoon burst can drop inches of rain in an hour on one neighbourhood and nothing three miles away. The water has nowhere to soak in, so it runs — into streets, into normally dry washes, and into homes through low doors, window wells and roof leaks.

Flood water is treated differently from a burst pipe. Water that comes from outside carries dirt, debris and whatever it picked up on the way in, so cleanup includes cleaning the surfaces it touched, not just drying them. Rooms are cleared, water is extracted, and flooring, baseboards and lower walls are checked for contamination as well as moisture.

The first hours matter most. Flood water that sits in a home keeps wicking into drywall and under flooring, and the EPA notes that mold can begin to grow on damp surfaces within 24 to 48 hours. Getting the water out and the drying started early is what keeps a flooded room from becoming a bigger job.

After a monsoon burst, the calls often come in clusters — one street, one low-lying area, one neighbourhood that took the heaviest cell. If your home took water during a storm, describe where it entered and how deep it got. That tells the crew what equipment to bring and whether the water is still rising.

Before you call

  • Shut off the main water supply if it is safe to do so.
  • Move valuables, rugs and electronics off wet floors.
  • Take photos of the water and the damage for your records.
  • Stay away from wet outlets, switches and light fixtures.
  • Note when the water started and what caused it, if you know.

Call Now

Understanding

How flood damage cleanup works

Cleanup starts with safety: water near electrical outlets, switches and panels is avoided, and the main supply is checked in case an inside source is adding to the flood. Then the water is extracted room by room, and the entry point is noted — a door threshold, a window well, a roof leak, a drain that backed up during the storm. Knowing how it got in matters for what happens next.

Once the standing water is out, the wet area is mapped. Flood water runs along the slab and under walls, so the mapped area is usually larger than the puddle was. Lower drywall, baseboards, carpet pad and cabinet bases are checked first, because those are the materials that sit in flood water longest. Readings are written down as the baseline for drying.

Cleaning follows the water source. Flood water is not clean water, so surfaces it touched are cleaned and, where needed, materials that cannot be cleaned are removed. Drying equipment is then placed on the mapped areas and readings are taken until the materials are dry. The final check is a moisture reading, not a look at the surface.

Included

What the service includes

Flood water extraction

Standing flood water removed from floors, carpet and low spots, room by room, starting where it is deepest.

Entry point check

Where the water came in is identified — door, window, roof leak, overwhelmed drain — so the next storm does not repeat the same damage.

Moisture mapping

Lower walls, baseboards, flooring and the slab are checked with meters, including rooms the water ran into unseen.

Cleaning of flood-touched surfaces

Surfaces the flood water touched are cleaned, because outside water carries dirt and debris with it.

Removal of unsalvageable material

Soaked pad, swollen cabinet bases and saturated lower drywall that cannot be dried or cleaned are removed.

Structural drying

Air movers and dehumidifiers dry the mapped areas, with readings taken during drying until materials read dry.

Contents protection

Furniture, rugs and belongings are moved off wet floors or blocked up while drying runs.

Documentation

Photos and readings from the cleanup give you a record for your insurer — and a note that flood water is usually a separate policy matter.

Process

How the work runs

1

Call and describe the flood

Where the water entered, how deep it got, whether it is still rising, and what it touched.

2

Stay safe around water

Avoid wet outlets and switches. Do not wade through water near electrical fixtures or panels.

3

Extract the water

Machines remove standing water room by room, starting at the deepest point.

4

Map and clean

The wet area is mapped with meters and flood-touched surfaces are cleaned.

5

Dry to readings

Air movers and dehumidifiers run until moisture readings show the materials are dry.

6

Final check

Readings are taken again and the entry point is reviewed so the next storm can be prepared for.

Tools & methods

Tools and methods used

Extraction machines

Truck-mounted and portable extractors move large volumes of flood water from floors and carpet.

Moisture meters

Meters read moisture in lower walls, baseboards and flooring so the full wet area is found.

Air movers

High-volume fans push dry air across wet surfaces and into wall cavities.

Dehumidifiers

Commercial dehumidifiers pull moisture from the air during drying.

Problem

A ground-floor room with flood water across the tile, a wet line on the drywall, and mud left behind.

Water that is left standing keeps spreading — into walls, under flooring, and into the next room.

Solution

Water extracted, flood-touched surfaces cleaned, structure dried to verified readings, and the entry point identified.

The work is checked with moisture readings, not a look at the surface.

Problems solved

Problems flood cleanup solves

  • Monsoon rain that entered through doors, windows and low spots.
  • Storm water that overwhelmed a drain and ran into a home.
  • Roof leaks during heavy bursts that sent water onto ceilings and floors.
  • Flood water that ran along the slab into rooms beyond the entry point.
  • Contamination left on floors and lower walls by outside water.

Call Now

Signs

Signs you need flood cleanup after a storm

  • Water on the floor after a monsoon burst, even if it has stopped raining.
  • A wet line on the wall showing how high the water reached.
  • Mud, silt or debris left on the floor after the water drained away.
  • Carpet or flooring that stayed wet after the storm passed.
  • A musty smell in a room that took water during a storm.
  • Baseboards or cabinet bases that swelled after the water came in.
Questions

Frequently asked questions

Questions people ask about flood damage cleanup, answered plainly.

Usually not by a standard homeowners policy. Flood — water that enters from outside, from the ground up — is generally excluded and needs a separate flood policy through the National Flood Insurance Program or a private insurer. Check your policy and talk to your insurer; keep photos and readings from the cleanup.

A burst pipe is water from inside the home, released suddenly — often covered by a standard policy. Flood damage is water from outside the home, such as monsoon rain or surface runoff — usually excluded from a standard policy. The source of the water decides how the claim is treated.

Small amounts of clean water can be mopped up, but flood water from outside carries dirt and debris, and the wet area is usually bigger than it looks. Hidden water in walls and under flooring needs meters to find. If the water is deep, contaminated, or near electrical fixtures, call for help.

Extraction happens in one visit in most cases; drying takes days, with readings checked along the way. The size of the wet area and how long the water sat decide the timeline. Readings, not the calendar, say when it is dry.

Move what you can off wet floors to a dry area, and take photos before you move anything. Rugs and soft furnishings that soaked up flood water may need cleaning or removal depending on the water and how long they stayed wet.

Start with the entry point found during cleanup — a door threshold, a window well, a drain, a roof leak. Clearing drains and gutters, checking door seals, and keeping water away from the foundation are the usual first steps. A roofer or drainage contractor handles the fix itself.

Water damage in your Phoenix home?

Call Now to reach a local water damage professional. Describe the water, where it is, and what it has touched.

Call Now

Contact

Call now for water damage help

Tap Call Now to reach a local water damage professional. Tell them where the water is, what it has touched, and whether it is still coming in.

Hours: Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

Call Now

Before you call

  • Shut off the main water supply if it is safe to do so.
  • Move valuables, rugs and electronics off wet floors.
  • Take photos of the water and the damage for your records.
  • Stay away from wet outlets, switches and light fixtures.
  • Note when the water started and what caused it, if you know.
Phoenix Water Damage Pros — helper
☎ Call Now